MDS MDS 9710 Series Spécifications télécharger pdf (Page 45)

MDS 05-3305A01, Rev. D MDS 4710/9710 I/O Guide 37

Invisible place holder

Figure 14. GE MDS InSite Radio Device User I/O Settings

(Bottom Left-hand Corner of Network Wide Radio Configuration Screen)

These output-only pins are designed for low switching rates and do not

pass high-speed data, nor are they suitable for latency-sensitive remote

controls. An example of this function is to reset the connected remote

RTU or turn on a security device at the associated transceiver’s location.

6.5 Upgrading the Radio’s Software

Windows-based Radio Configuration software is available (MDS P/N

03-3156A01) for upgrading the internal radio software when new fea-

tures become available from GE MDS. Contact GE MDS for ordering

information.

To connect a PC to the radio’s

DIAG. port, an RJ-11 to DB-9 adapter

(MDS P/N 03-3246A01) is required. If desired, an adapter cable can be

made using the information shown in Figure 13.

Using the Radio Configuration software, select

RADIO SOFTWARE

UPGRADE

under the SYSTEM menu. Follow the prompts and online

instructions to determine how to proceed.

Green Indicates

current output state

at associated radio

transceiver is “high”.

Click to set

output to “low”.

Table 12. User-Programmable Interface Output Functions

via Transceiver Interface Port

Function Interface

States

Compatibility

Digital Output #1 Pin 22 Set = 3 Volts

Clear = 0 Volts

CMOS

Digital Output #2 Pin 15 Set = +9.5 volts

Clear = –9.5 Volts

EIA-232 Compatible

Digital Input Pin 16 Set = 5 volts

Clear = 0 volts

CMOS

a.Voltages are typical and varies with load.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

Pas de commentaire

MDS MDS 9710 Series Spécifications Page 45